The S.M. SERIES DIAMOND CORE BIT

These bits are designed specially for small diameter holes, 1-3/8" and smaller. When cutting small holes, large reinforcing rods and heavy psi concrete can wipe out bits quickly. Drillco has formulated the S.M. Series matrix to achieve maximum speed and performance. Ideal when a carbide bit encounters rebar and can not complete the job. Available in 5/8"-11 threads.

(Click on Image to see table)

The C.S. SERIES DIAMOND CORE BIT

Drillco uses its own specially formulated matrix to produce its C.S. Series. The C.S. Series is designed for heavy duty coring applications and works best in heavily reinforced concrete. For 30 years the C.S. Series has been the preferred core bit for contractors who do a great deal of core drilling and prefer speed along with longevity out of their core bits.

(Click on Image to see table)

C.S.Bit
The C.S.B. SERIES DIAMOND CORE BIT

The C.S.B. Series is preferred by contractors whose initial cost is a factor. The C.S.B. Series is an exceptional value for those with light to medium coring applications.

(Click on Image to see table)

The AIR COOLED

Drillco's Air Cooled diamond bits are designed for the dry coring of holes through lightweight concrete materials such as brick, block and masonry products. Not recommended for heavy psi concrete or reinforced concrete. The CSA diamond bit allows the contractor to core clean cut holes quickly with minimal patching.

  • Deeply embedded segments to prevent segment loss.
  • Cross Drilled holes keep bit cool for rapid cutting.
  • Built in 5/8-11" head for use with hand held grinders and core machines.

(See table below)

Special sizes for the Air cooled bit available
Size
Part #
Size
Part#
1-1/2" x 10"
CSAC 1500
3-1/2" x 10"
CSAC 3500
2" x 10"
CSAC 2000
4" x 10"
CSAC 4000
2-1/2" x 10"
CSAC 2500
4-1/2" x 10"
CSAC 4500
3" x 10"
CSAC 3000
5" x 10"
CSAC 5000

To Top of Page